CO₂ Regulator Washer (flat seal), Taprite
$ 0.99
TAPREG-WASHER
Product Overview
Specifically designed for Taprite® primary regulators featuring the high-performance red polycarbonate bonnet.
Restores the "permanent" seal on the regulator inlet nipple, eliminating the need for temporary fiber washers during every tank swap.
Can be swapped out in seconds using a standard #4 Allen wrench (hex key) to remove the retaining screw and seat the new seal.
Maintain a perfect, airtight connection between your CO2 tank and your Taprite® T742HP Series regulator with this genuine replacement flat seal. Known for its distinct red bonnet, the T742HP primary regulator features a built-in washer design that occasionally requires maintenance to prevent "slow leaks" and gas loss.
This flat seal is a direct replacement for the original "permanent" washer found at the end of the regulator stem. Over time, or through accidental overtightening, the original seal can become compressed or scarred. Instead of replacing the entire regulator, this inexpensive part allows you to restore your equipment to factory-spec performance in minutes.
The washer is easily replaced using a #4 allen wrench (hex key).
Specifications
Specifications
Includes
Includes
